Automatic Feed; For Tpr-1230, Tpr-1230H - Sharp RD-1230 Operation Manual

5.12 Automatic Feed.

5.12.1 （For TPR-1230, TPR-1230H）
Ⅰ. Automatic feed rate table
Steps
Feed rate
Ⅱ. Change the feed rate as the following way:
a. Stop the spindle.
b. Press down the emergent stop button.
c. Check the speedometer and choose a suitable rate.
d. Switch the feed rate.
Precaution when at changing feed rate:
You can change the feed rate only when the spindle is rotating.
Ⅲ. Suppose that the work piece is by the machine
The way to move(less than 25kgs.)
Suppose that the work piece is by the machine, the way to move it is as follows:
1. Power off.
2. Put on gloves.
3. Squat facing the work piece.
4. Lift the work piece with two hands.
5. When you are standing up, lift and move the work piece with your feet strength.
6. Move the work piece toward the worktable.
The way to move(greater than 25kgs.)
Suppose that the work piece is by the machine, the way to move it is as follows:
1. Power off.
2. Put on gloves.
3. Push the arm backwards.
4. Move a lifting devise close to the work piece.
5. Place lifting ropes or slings under the work piece, (please use two ropes or
slings). If the work piece has holes for lifting ropes or slings, please lock it with
ring head pin, then lift and move it with a hook.
6. Move the work piece toward the worktable.
N
No feed rate 0.05mm/Rev 0.09 mm/Rev 0.15 mm/Rev
5-22
1 2 3