Sharp RD-1230 Operation Manual page 3

Section Content
4.2.2 The movement of the machine
4.2.3 The order to pack ..................................................................... 4-3
4.3 Installation of the machine
4.3.1 Have the machine set onto the fastening bolts of the crate base
4.3.2 Level adjusting. ...................................................................... 4-4
4.3.3 The installation of the electricity
4.4 The test after installation
4.5 The procedure for dismantling the machine
CHAPTER 5 Operation
5.1 A brief introduction to the relevant operation hardware
5.1.1 (For TPR-1230, TPR-1230H)
5.1.2 (For TPR-1600H, TPR-2000H)
5.1.3 Safty protective device (suit every model)......................................... 5-5
5.2 Instruction to switches
5.2.1 (For TPR-1230, TPR-1230H)
5.2.2 (For TPR-1600H, TPR-2000H)
5.3
Installation of the clamp（work piece）
5.3.1 General ............................................................................... 5-9
5.3.2 Introduction of the vise and the clamping of the work piece
5.3.3 Universal clamp and the clamping of the work piece
5.4 Installation and change of the drilling bit
5.4.1 The assembly and disassembly of the drilling head and clamp
5.4.2 The assembly and disassembly of the straight handle drill bit
5.5 Power on and off ..................................................................... 5-13
5.5.1 Power on .............................................................................. 5-13
5.5.2 Power off .............................................................................. 5-13
5.6 Work light ............................................................................ 5-14
5.7 Cutting fluids ........................................................................ 5-14
5.8 Elevating the arm ..................................................................... 5-14
5.9 Rotate the Gearbox right or leftwards
5.9.1 (For TPR-1230,TPR-1230H）
5.9.2 For TPR-1600H, TPR-2000H）
5.10 Rotate the arm forward or backwards
5.10.1 (For TPR-1230,TPR-1230H)........................................................ 5-16
5.10.2 (For TPR-1600H, TPR-2000H)...................................................... 5-16
5.11 Change the spindle speed
5.11.1 (For TPR-1230,TPR-1230H)
5.11.2 (For TPR-1600H, TPR-2000H)
................................................ 4-2
...................................................... 4-3
............................................. 4-4
............................................. 4-4
............................................... 5-1
............................................. 5-3
........................................................... 5-6
................................................ 5-6
................................................ 5-8
..................................... 5-9
....................................... 5-15
......................................... 5-15
............................................. 5-15
....................................... 5-16
....................................................... 5-17
............................................. 5-17
............................................. 5-20
0-2
................................ 4-4
................... 5-1
............ 5-9
.................... 5-10
................................. 5-11
........... 5-13
page
.......... 4-3
......... 5-11