Delaying Channel Signals - Yamaha 01V Owner's Manual

Delaying Channel Signals

The Channel Delays, available on input channels 1 through 16, can be used to compen-
sate for microphone placement, or simply as delay effects. The delay parameters for
input channels 1 through 8 are on DELAY page 2, while those for input channels 9
though 16 are on DELAY page 3. Both pages are shown below.
1. Use the [ /DELAY] button to locate DELAY page 2 or 3, as shown below.
2. Use the [SEL] buttons to select channels.
3. Use the cursor buttons to select the delay parameters and the [ENTER]
button, PARAMETER wheel, or [–1/DEC] and [+1/INC] buttons to set
them.
Parameter Range
ON/OFF
ON/OFF
DELAY
0–250 ms
MIX
–100 to +100
FB. GAIN
–99 to +99
The Channel Delays on input channels 13 and 14 (likewise 15 and 16) are permanently
linked. When input channels 1 through 12 are paired ("Pairing Input Channels" on
page 52), their Channel Delays are linked, so adjustments can be made with either
channel selected.

Delaying Channel Signals

Description
These switches are used to turn on and off the delays.
Delay can be specified in milliseconds, meters, or samples
("Setting 01V Preferences" on page 203). The maximum
delay in samples is fixed at 11025. The maximum delay in
milliseconds and meters depends on the sampling rate. At
44.1 kHz, for example, it is 250 milliseconds and 85.2
meters, respectively.
This parameter determines the level of delayed signal. 0 is
no delay. +50 is a 50/50 mix of delayed and dry signals.
+100 is all delay, no dry. Negative values are the same
except the delayed signal is phase reversed.
This parameter determines how much of the delayed sig-
nal is fed back into the delay. 0 is no feedback. +99 is
maximum feedback. Negative values are the same except
the feedback signal is phase reversed.
45
01V—Owner's Manual