Replacing the Connector Assembly or the Bottom Housing
Revision B
Field Replaceable Units: Docking Station Assembly
1. Separate the top and bottom housings.
2. Use a 10 mm wrench or nut driver to remove
3. Remove the three PCB bracket screws.
4. Lift out the connector assembly.
025A
5. Stabilize the LED component and gently pull
026A
'$0$*(' +286,1* 127(
If you are replacing the bottom housing, you must
install the light pipe into the new housing.
027A
Dash Port Docking Station
2000966-037
the equipotential lug.
out the light pipe from the PCB.
Route the light pipe through the opening into
the housing and snap it into place.
See
"Exploded View PN 2004740-001, Revision
D"
on page 6-3 to apply the labels to the
housing.
5-5