Table of Contents
Advertisement
Disassembly Guidelines
Tools Required
Before Disassembly
Hardware Assemblies
After Reassembly
Recommended Electrical Safety Tests and Checkout Procedures
Replacement Procedure
Locking Assembly
Top Housing
Connector Assembly
Bottom Housing
Revision B
Field Replaceable Units: Disassembly Guidelines
A standard set of hand tools is required for disassembly and assembly.
Before you disassemble the docking station, you should ALWAYS remove
AC power.
When disassembling the docking station, observe the following
guidelines:
Provide appropriate electrostatic discharge protection and handle all
PCB assemblies by their edges to prevent damaging the PCB.
Note the positions of wires, cables, and different sized screws;
marking them if necessary to ensure they are replaced correctly.
Save and set aside all hardware for re-assembly.
After reassembling the docking station, ALWAYS complete ALL of the
checkout procedures, electrical safety tests, and regular maintenance
procedures identified and described in this service manual.
Electrical Safety Tests
"Wall Receptacle Test"
on page 3-7.
"Ground (Earth) Integrity"
"Ground (Earth) Wire Leakage Current
Tests"
on page 3-10.
"Enclosure Leakage Current Test"
page 3-12.
Dash Port Docking Station
2000966-037
Checkout Procedures
"Verify Correct Docking Station
on page 3-8.
Operation"
"Docking Station Power-up Tests"
page 3-18.
on
"Network Test"
on page 3-17.
on
on page 3-19.
5-3
Advertisement
Table of Contents
