Mitsubishi Electric MELSEC Q Series User Manual page 30

2 SYSTEM CONFIGURATION
2 - 3
Downloaded from ManualsNet.com
(b) Mounting to a MELSECNET/H remote I/O station
The table below shows the network modules and base units applicable to
the Q64TC and quantities for each network module model.
Depending on the combination with other modules or the number of
mounted modules, power supply capacity may be insufficient.
Pay attention to the power supply capacity before mounting modules, and if
the power supply capacity is insufficient, change the combination of the
modules.
Applicable network
Q64TCTT/
module
Q64TCRT
QJ72LP25-25
QJ72LP25G
QJ72LP25GE
QJ72BR15
*1: Limited within the range of I/O points for the network module.
*2: Can be installed to any I/O slot of a base unit.
Remark
The Basic model QCPU or C Controller module cannot create the MELSECNET/H
remote I/O network.
(2) Support of the multiple CPU system
When using the Q64TC in a multiple CPU system, refer to the following manual
first.
• QCPU User's Manual (Multiple CPU System)
(a) Compatible Q64TC
Use the Q64TC with function version B or higher if using the module in a
multiple CPU system.
(b) Intelligent function module parameters
Write intelligent function module parameters to the control CPU of the
Q64TC.
(3) Compatibility with online module change
To make an online module change, use the module of function version C or later.
POINT
The products of function version C include the functions of the products function
versions A and B.
search engine
No. of modules 1
Q64TCTTBW/
Q64TCRTBW
Up to 64 Up to 32
MELSEC-Q
Base unit 2
Main base unit of Extension base unit of
remote I/O station remote I/O station
○
○: Applicable,×: N/A
○
2 - 3