NEC SL2100 Hardware Manual page 158

ISSUE 4.0
6.4.3 Connecting the Telephone Cords
When connecting the telephone cords, observe the following precautions.
• Never install telephone wiring during a lightning storm.
• Never touch bare telephone wires or terminals unless the telephone line is
disconnected at the network interface.
• Use caution when installing or modifying telephone lines.
To connect the telephone cords:
1. Connect one line cord from SL2100 digital station port to the Line In connector on the DTZ-8R-1
Cordless DECT base unit. Connect another line cord from the Line Out connector to a qualified
digital multiline telephone.
Do not connect the DTZ-8R-1 line cord directly to SL2100 station board as the DTZ-8R-1 will not function.
Connect the line cord to the jack with a single pair connected back to one digital station port.
6.4.4 Applying Power to the Charging Unit
The unique design of the telephone allows the user to place the handset in the charging unit with or
without the belt clip attached.
Connect the AC adapter with the green tip to the charging unit and to a suitable AC power source. The
battery pack is charged automatically when the handset is placed on the charger.
INSTALLING WIRELESS DECT TELEPHONES
Figure 2-162 Connecting Telephone Cords
SL2100
156