Panasonic BB-HCM381A Service Manual page 46

- Adjustment completes with no error Displays the error item
5. See SECTION 12.4&12.5 TROUBLESHOOTING for the error item.
11.5. VIDEO ADJUSTMENT PROCEDURE
1. Tools
- Collimator
- Light Box
- Color Chart
- Color Temp. Conversion Filter for 5100K
2. Adjustment Procedure
1. Place the Color Temp. Conversion Filter in the HP light box.
2. Remove the Focus Chart block from the Collimator and attach it with
screwing its end into the rotating ring on the front of the light box.
3. Start-up the HCM PTZ CAMERA Service Tool.
4. Select Model Name: HCM381A
5. Install the Active-X for the Video Adjustment to the PC.
6. Connect the tool board to the tilt board of the set.
7. Turn on the Set.
8. Execute browser (IE) and open the single camera page.
9. Adjust the set's lens as the same height as the collimator, and perform
an image pickup of the inside of the collimator.
10. Press the "Video Adjustment" button.
11. After displaying "Please shoot the Light Box without chart" and adjust
the position and zoom range without the Color Chart so that the White
image is displayed in the full screen.
12. Press the "OK" button.
13. Follow the message after displaying dialog.
14. After displaying "Please shoot Color Chart", set the Color Chart to HP
light box. Adjust the position and zoom range so that the Color Bar
Chart is displayed in the full screen and the target on the screen is
placed in the center of each color, as shown in the following Figure.
15. Press the "OK" button.
46
*1