Note:
If this camera is installed in a commercial or industrial building, local building code may require specific
installation methods to be used. In such cases we strongly suggest that you contact your local building
inspector so that the installation complies with any applicable building code.
8.2. MOUNTING ON THE CEILING
Please set the Tilt range to [On the ceiling] on Camera Setup window on Operating Instruction. Two
ways of wiring can be considered; wiring through a hole made in the ceiling or wiring without making a
hole for a cable in the ceiling. Please select either one of the two.
Wiring through a hole made in the ceiling
1. Fix the Ceiling Plate B on the ceiling with Screws B.
- Fix the Ceiling Plate B more than 100 mm (4 inches) off the wall or other
obstacles from its center.
- Make sure the Network Camera is firmly mounted on a beam of wood
etc. When there is no beam, apply a board on the other side of the
ceiling to make sure the Network Camera does not drop.
18