Table of Contents
Advertisement
Filling the Fuel Tank
Capacity: 5.4 L (5.7 US qt)
1.
Park the machine on a level surface, shut off the
engine, and allow the engine to cool.
2.
Clean around the fuel-tank cap and remove it
(Figure
13).
Figure 13
1. Fuel-tank cap
2. Inlet fuel screen
Important:
Keep the inlet fuel screen and
the red ring in the fuel tank while pouring the
fuel.
3.
Add fuel to the fuel tank until the level is up to
the red ring
(Figure 13
Important:
This space in the tank allows
the fuel to expand. Do not fill the fuel tank
completely full.
Figure 14
4.
Install the fuel-tank cap securely.
5.
Wipe up any fuel that may have spilled.
g038408
3. Red ring
and
Figure
14).
g038409
During Operation
During Operation Safety
General Safety
•
The owner/operator can prevent and is responsible
for accidents that may cause personal injury or
property damage.
•
Wear appropriate clothing, including long pants;
eye and hearing protection; slip-resistant,
substantial foot protection; and hard hats. Tie back
long hair and do not wear jewelry.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
Operate the machine only in good visibility to avoid
holes or hidden hazards.
•
Keep your hands and feet away from moving parts.
•
Do not operate near drop-offs, ditches, or
embankments.
•
Stop the machine whenever you are not operating
it.
•
Never run an engine in an area where exhaust
gasses are enclosed.
•
Never leave a running machine unattended.
•
Before leaving the operating position, do the
following:
– Move the machine to level ground.
– Shut off the engine and remove the key.
– Wait for all moving parts to stop.
•
Do not operate the machine when there is the risk
of lightning.
•
Use accessories, attachments, and replacement
parts approved by The Toro® Company only.
Starting and Shutting Off
the Engine
WARNING
If you run the engine when the mixing valves
are not adjusted as directed, the pump can
direct fluid out through the hopper and push
the grate into the air.
Ensure that the mixing valves are adjusted
appropriately and that the grate is tethered to
the hopper, before starting the engine.
11
Advertisement
Table of Contents
