Table of Contents
Advertisement
Starting the Engine
Important:
Because the fluid cools the pump
seal, the pump may overheat if you run the engine
without fluid in the mixer. Do not run the engine
without fluid in the mixer.
Starting the Engine using the Key Switch
1.
Move the fuel-shutoff lever to the
2.
Move the speed-control handle to the right
(Figure
11); refer to
Note:
If smoke comes from the exhaust, move
the speed-control handle to the left.
3.
Rotate the ignition switch to the R
(Figure
11); refer to
Figure 15
1. Stop position
2. Run position
4.
Turn the ignition switch to the S
and hold it there until the engine starts
15).
Important:
If the engine does not start
within 15 seconds, release the key, and wait
at least 10 seconds before operating the
starter again. Using the electric starter for
too long will overheat the starter motor and
can damage it.
Note:
If after several attempts of starting the
exhaust begins to emit white smoke, move the
speed adjustment lever all the way to the left,
and pull the recoil-start handle out slowly 5
times. Repeat the starting procedure.
Starting the Engine using the Recoil Handle
1.
Move the fuel-shutoff lever to the
2.
Move the speed-control handle to the right
(Figure
11); refer to
Note:
If smoke comes from the exhaust, move
the speed-control handle to the left.
position.
ON
Controls (page
8).
position
UN
Ignition Switch (page
9).
3. Start position
position,
TART
(Figure
position.
ON
Controls (page
8).
3.
Push the decompression lever to the left
10).
Note:
The decompression lever will stay
cocked to the left and will automatically return
to the original position when the recoil starter
handle is pulled again.
4.
Grasp the recoil-start handle, pull it out slowly
until you feel resistance, then pull it all the way
out with a strong and even motion
Note:
Use 2 hands if necessary.
5.
Slowly return the recoil-start handle to the initial
position.
6.
If the engine does not start, repeat steps
g024065
Shutting Off the Engine
WARNING
In an emergency situation, shut off the engine
immediately.
1.
Move the speed-control handle to the S
position
(Figure
(page
9).
2.
Rotate the ignition switch to the O
refer to
Ignition Switch (page
3.
Move the fuel-shutoff lever to the
Important:
Keep the ignition switch in the
position. Leaving the ignition switch in the
position while the engine is off will discharge the
battery.
12
(Figure
Figure 16
11); refer to
Ignition Switch
position;
FF
9).
position.
OFF
(Figure
16).
g022414
1
to 5.
TOP
OFF
RUN
Advertisement
Table of Contents
