Table of Contents
Advertisement
38
www.husqvarna-electrolux.se
Problem
The oven does not heat up.
The lamp does not operate.
The display shows "12.00".
The display shows F11.
Steam and condensation
settle on the food and in the
cavity of the oven.
13.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
14. ENERGY EFFICIENCY
14.1 Product information for hob according to EU 66/2014
Model identification
Type of hob
Number of cooking zones
Heating technology
Diameter of circular cooking
zones (Ø)
Possible cause
The necessary settings are
not set.
The lamp is defective.
There was a power cut.
The plug of the core temper-
ature sensor is not correctly
installed into the socket.
You left the dish in the oven
for too long.
on the front frame of the oven cavity. Do
not remove the rating plate from the
oven cavity.
.........................................
.........................................
.........................................
QSI7134W
Hob inside Freestanding Cooker
4
Induction
Left front
Left rear
Right front
Right rear
Remedy
Make sure that the settings
are correct.
Replace the lamp.
Reset the clock.
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
21.0 cm
21.0 cm
21.0 cm
21.0 cm
Advertisement
Table of Contents
