Table of Contents
Advertisement
...7.1 Factory Settings
50. 0
mg/l C
48. 2
mg/l C
A: Fill Sol. 2
25.0
48. 2
R100.0
100%
80. 0
mg/l C
78. 6
mg/l C
A: Fill Sol. 3
10.0
80. 0
R100.0
100%
0. 9 3
lo
1. 1 6
hi
A:Cal. Complete
Factory Cal. A
Calibrate with Solution 2
Fill the flowcell with a 10mgl
standard solution prepared from the stock standard solution – see Section 4.1.2.
Press the
key to initiate calibration.
Note. If the
key is pressed again at any time before calibration is complete, the
calibration is aborted and the display advances automatically to the next step.
Raw Output from Sensor
Organic signal
Reference signal
As calibration proceeds, a progress indicator appears in the lower display line. After 3
minutes, the lower display line shows
automatically to the next step.
Calibrate with Solution 3
Fill the flowcell with a 15mgl
standard solution prepared from the stock standard solution – see Section 4.1.2.
Press the
key to initiate calibration.
Note. If the
key is pressed again at any time before calibration is complete, the
calibration is aborted, the display advances automatically to the next frame and
is shown on the lower display line.
A:Cal Incomplete
Raw Output from Sensor
Organic signal
Reference signal
As calibration proceeds, a progress indicator appears in the lower display line. After 3
minutes, the lower display line shows
automatically to the next step.
Calibration Completed
is displayed to indicate a successful calibration.
Cal Complete
Note.
is displayed if any part of the is calibration is aborted.
Cal Incomplete
Sensor B calibration (dual input monitors only) is identical to Sensor A
Factory Cal. B
calibration.
Single input monitors only – continued on page 46.
Cal. Output 1
Operating Page – see Section 2.3.
Diss. Organics
–1
(7320 100 sensor) or 50mgl
100%
–1
(7320 100 sensor) or 80mgl
100%
7 CALIBRATION...
–1
(7320 200 sensor) span
, the display then advances
–1
(7320 200 sensor) span
, the display then advances
47
Advertisement
Table of Contents
