Table of Contents
Advertisement
Test No
4 Sec Moisture Sensor test
06
07
08
Last stored Fault Code
09
NOTE
* The Moisture Sensor is to the lower left inside the door beside the lint screen. The Technician may use
metal to short sensor bars. The sensor is touch safe, some materials like dry fingers or a 10 Kohm resistor
should have no displayed value.
10.3 Clearing Error Codes
To clear stored error codes, press and hold Start and Temperature buttons simultaneously for 5 seconds.
10.4 Exit Diagnostic Mode
To exit Diagnostic mode, hold the Power key for 3 secs, when not in '00 test step Lights / Buttons, or unplug
the unit.
10.5 Factory Default Reset
To set Factory Default Reset, follow the instructions mentioned below:
•
Press Power and look for console light up.
•
Within 7 seconds, press and hold simultaneously Dry Level + Options for 3 seconds.
10.6 Demo Mode
The Demo works in following two ways:
1.
Interactive mode
2. Automatic loop.
Interactive mode: The Interactive mode enables the customer to use interface without activating the Appliance.
The machine behavior appears similar to operation. Start turns the Drum light ON and if the door is closed the
ETR is decreased each second. The mist valve is not activated.
Automatic loop: If no one interacts with the interface for 3 minutes, or Start button has not been pushed,
the machine enters an automatic loop instead, simulating the cycle execution appears only on display. This
Automatic loop cycles until someone touches the user interface and it goes back to Interactive mode.
Test Name
Fault Code
No Test
Purpose of the test
Test the Moisture bars
Check Faults
Check Faults
41
Diagnostic System
Test Results
000 will flash if test fails
Review last fault code stored
Review last fault code stored
Hide quick links:
Advertisement
Table of Contents
