Unpack Retrofill Circuit Breaker - ABB Emax 2 Installation And Maintenance Manual

Unpack Retrofill Circuit Breaker

By following the procedures below, one should be able to install the breaker with minimum
effort and time.
Danger

Ensure only qualified personnel install, operate, service and maintain all electrical
equipment.
Caution

Ensure lifting equipment has capability for device being lifted.

Wear hard hat, gloves and safety shoes.

Failure to comply with these instructions could result in serious injury.
Notice

20| © 2020 Emax 2 Retrofill Circuit Breakers 600A-4000A
Falling Object
A factory-installed rejection feature prevents mismatching circuit breakers and
cassettes/ substructure, preventing the insertion of a circuit breaker with a lower
rating into a higher rated cassette/substructure or the insertion of a higher rated
circuit breaker into a lower rated cassette/substructure.

Turn off all power to switchgear. Tagout
and lockout main source, up-stream or main
breaker.

Failure to comply with these instructions
will result in death or serious injury from severe
burns caused by arc flashing that has
exceedingly high temperatures.

Always wear personal protection equipment
according to OSHA standards and appropriate
to the severity of potential burns.

Do not walk or remain under any heavy
assembly while hoisted above head as the
chains securing the assembly may give way.
PRODUCT DAMAGE

Ensure circuit breaker and its accessories are always
used within their designated ratings.

Do not allow the circuit breaker to hit a hard surface
while handling.

Do not drag or slide the circuit breaker across a hard
or rough surface
2TSA451011P0000 Rev-B