Table of Contents
Advertisement
Speakers to be connected
Speaker type
Front (L/R) 1 2
Center 3
Surround (L/R) 4 5
Surround back (L/R) 6 7
Front presence (L/R) E R
Subwoofer 9
If you have nine speakers, you can connect the both surround back speakers and front
presence speakers. In this case, the unit automatically changes the speakers to be used,
depending on the input signal and CINEMA DSP.
If you have seven speakers, use two of them as surround back speakers (*1) or front presence
speakers (*2).
If you have five speakers, use two of them as surround speakers (*3) or front presence speakers
(*4).
X
• When using surround back speakers, be sure to connect the surround back left and right speakers. Using only
one surround back speaker was discontinued.
• You can also connect up to 2 subwoofers (with built-in amplifier) to the unit.
• When apply this speaker configuration, set "Power Amp Assign" (p.113) to "Basic" (default).
• To use an external power amplifier (Hi-Fi amplifier, etc.) to enhance speaker output, see "Connecting an
external power amplifier" (p.31).
Cables necessary for connection (commercially available)
Speaker cables (x the number of speakers)
Audio pin cable (two for connecting two subwoofers)
Speaker system
(the number of channels)
7.1/5.1.2
5.1
2.1
(
(
(
(
(
(
)*3
)*1
)*2
)*4
(
(
(
Connection diagram
Refer to the following diagram and connect the speakers to the unit.
ZONE OUT
PRE OUT
1
2
The unit (rear)
ZONE 2
FRONT
SURROUND
SUR. BACK
SUBWOOFER
CENTER
EXTRA SP2
R
L
R
L
SURROUND
SURROUND BACK
ZONE 2
E
1
9
3
4
6
24
En
SPEAKERS
EXTRA SP1
R
L
R
L
CENTER
FRONT
F.PRESENCE
ZONE 2/BI-AMP
R
2
9
5
7
Advertisement
Table of Contents
