Table of Contents
Advertisement
Symptom
The Jet Bot does not detect the
Boundary Marker and crosses
the boundary.
The Jet Bot suddenly cleans
diagonally.
Jet Bot does not clean some
places.
The Jet Bot cannot find a room.
The map which the Jet Bot has
created is different from the
saved map and the map is also
drawn askew.
The Jet Bot does not detect and
crosses No-go Zones.
40
English
• Make sure the Boundary Markers are attached as (
shape at 15 cm before the locations where the Jet Bot
should not cross.
• Check if the Docking Station is installed along the grain
of wooden floors or tiles.
• The Jet Bot may clean in a diagonal direction if it is
moving to another area using the shortest route. It
may also move at a diagonal if it did not make contact
with an obstacle at a right angle, if it was charged in a
skewed direction at the Docking Station, or If the floor
material is wooden or tile.
• Check whether the Docking Station is installed in a
narrow passage or near a room door and move it to
another place.
– If the Docking Station is installed in a narrow passage
or near a room door, the Jet Bot cannot pass through
the passage or the door.
• Check whether the places the Jet Bot does not clean are
set as No-go Zones.
• If the Jet Bot does not start cleaning from the Docking
Station, or if the Docking Station is reinstalled to a new
position of 45 degree or 1 m or more from the previous
installed place, the Jet Bot cleans all areas, which is not
based on the created map.
– Start cleaning from the Docking Station.
– When the Jet Bot creates a map and the Jet Bot
starts cleaning, make sure the Jet Bot starts
operating parallel to the wall.
– Remove obstacles within 0.5 m of the left and right
side and 1 m of the front side of the Docking Station.
• If the Jet Bot does not start cleaning from the Docking
Station, the set No-go Zones function does not work.
Therefore, start cleaning from the Docking Station to
use the function.
Checklist
)
Advertisement
Table of Contents
