Table of Contents
Advertisement
Mounting
The encoder with the supplied mounting brackets is designed for installation in an EIA
standard 19-inch (480 mm) equipment rack. When mounting the encoder in a rack, use pan or
round head screws and washers in all four front panel mounting locations. This ensures a
secure mount for the size and weight of the unit. Please provide screws that match the rack.
SE encoders are stackable, one on top of another, within a rack, without any spacing
requirements. Place each SE encoder in a stable and level position within the rack and ensure
that all front enclosure screws are tightened to 2 ft.-lbs. If multiple SE encoders are installed
in a rack assembly, the operator may choose to have a certification agency evaluate the
condition of the rack.
Positioning
When positioning the SE encoder:
•
•
•
•
•
For signal information for the various connectors, see "Connector Pinouts" on page 29. The
following diagram shows the back panel.
FORM_C OUT
CC/LOG PORT
ETHERNET
COM NC NO
Form_C Out
Ethernet
CC/Log Port
DHEI Out
4
To prolong service life, make sure that the area around the SE encoder is free of dust and
other airborne particles.
Operate the SE encoder in a temperature-controlled environment. Do not place the
encoder near a heat source.
Do not install multiple SE encoders so that the air intake from one unit is aligned with the
outlet of another.
Do not install an SE encoder in areas of high humidity or where water can infiltrate the unit.
To avoid magnetic interference from the high-voltage cable, do not run AC power cables
and signal leads in the same duct.
DHEI OUT
ASI OUT
ASI MON
DS3 OUT
ASI
DS3
Note: For applications that use the Analog Video In
connector, attach a 75–ohm termination to the Analog
Video Loop Thru connector.
DIGITAL
DIGITAL
DIGIT A L VIDEO
DIGITAL
ANALOG VIDEO
AUDIO IN A
AUDIO IN B
LOOP THRU
VIDEO IN
LOOP THRU
Digital
Digital
Analog
Audio
Video
Video
SE-1010 / SE-2000 Encoder Product Manual, Version 1.0
ANALOG
ANALOG AUDIO A IN
ANALOG AUDIO B IN
VIDEO IN
L+ L- GND R+ R-
L+ L- GND R+ R-
Analog
Audio
Power
Note: Clip the supplied cord
retainer on the two standoffs.
AC
Advertisement
Table of Contents
