Table of Contents
Advertisement
① Align the mounting holes in the inner rail with the corresponding rail mounting pins on the
side of the enclosure.
② Push the inner rail as shown until the mounting pins on the enclosure lock into place with the
inner rail.
Note: Make sure the stamp "Front" always faces toward the front when assembling the inner rail to
the enclosure.
Step 3.
Repeat the previous step on the other inner rail.
Step 4.
Install the rear mounting bracket of the right outer rail to the lower EIA flange.
Figure 20. Installing the rear mounting bracket to the EIA flange
① Align the rear pins on the outer rails to the EIA flange.
② Slightly push the end of the rail down to hook the rear mounting bracket latch to the rack.
③ Push the rail into the EIA flange until the pins protrude through into the corresponding holes
in the rack.
④ The bracket will lock into place as illustrated.
Step 5.
Install the front mounting bracket of the right outer rail to the lower mounting flange.
.
Chapter 6
Installing optional kits
21
Advertisement
Table of Contents
