4. At both ends of the link enter ether an 128-bit or 256-bit encryption key. Note the key consists
of 32/64 case insensitive hexadecimal characters. The same Key must be entered at both ends
of the link. Failure to enter the same key will cause the link to fail.
5. Submit configuration on both ends of the link, but do not reboot.
6. Reboot both ends of the link
that a user can command both ends of the link to reboot before the wireless link drops.
AES Encryption Upgrade
Figure 124 AES Configuration Data Entry Page
Figure
125. The software is designed to allow five seconds so
Figure 125 Configuration Reboot Screen
165