Recovery Mode; Recovery Mode Warning Page; Recovery Options Page - Motorola PTP 300 series User Manual

Recovery Mode

9 Recovery Mode
The Motorola PTP 300 point-to-point wireless Ethernet bridges have a special mode of operation
that allows the user to recover a unit from configuration errors or software image corruption.
Recovery mode is entered by depressing the Recovery Switch located on the underside of the PIDU
Section 3.3.2
Plus while applying mains power, as shown in "PIDU Plus - PTP 300 Series Bridge".
The Recovery Switch should be held in the depressed state for between 10 and 20 seconds after
the application of mains power. The Ethernet LED will flash with 10 double flashes at power up
(following the release of the Recovery switch).
When in recovery mode the user will be able to access the unit via the Ethernet interface. The
Ethernet interface will have its IP address set to 169.254.1.1. On connection to a unit in recovery
mode the following screen is displayed Figure 78:
Figure 78 Recovery Mode Warning Page
Clicking on the warning page image will take the user on to the Recovery Option Page (Figure 79).
Figure 79 Recovery Options Page
118