Upgrade Software Image; Software Download Progress Indicator Page - Motorola PTP 300 series User Manual

The recovery options available are:
Upgrade Software Image:This allows the user to reload a software image. This may be the
original image if software corruption is suspected or a step back to an old image if an incorrect
image has just been loaded.
Reset IP and Ethernet Configuration back to factory defaults:This allows the user to
reset the unit back to the factory defaults:
IP Address 169.254.1.1
Netmask 255.255.0.0
Gateway 169.254.1.0
Ethernet Interface Auto-negotiate, Auto-MDI/MDIX
Erase Configuration:This allows the user to erase the unit's entire configuration. Executing this
option will also erase factory settings such as target MAC address, range setting, license key, etc.
Zeroise Critical Security Parameters:This allows the user to erase the security parameters
such as AES parameters. This is to comply with FIPS requirements.
Reboot:This allows the user to reboot the unit. This option must be executed after resetting the
IP and Ethernet configuration or erasing the configuration detailed above.
Software Version:This is the software version of the recovery operating system permanently
installed during manufacture.
Recovery Reason:Indicates the reason the unit is operating in Recovery mode. Possible reasons
are "Recovery button active" or "Invalid or corrupt image"
MAC Address:The MAC address shown here is the MAC address of the unit programmed during
manufacture.

9.1 Upgrade Software Image

The first step (Figure
downloaded. Once located the user should press the "Upgrade Software Image" button to start
the software download process.
During software download, progress is indicated by a pair of progress bars
Recovery Mode
79) is to use the 'Browse' button to locate the software image to be
Figure 80 Software Download Progress Indicator Page
119
80).
(Figure