Installing The Handle Assembly; Handle Assembly; Bolts; Curved Washers - Toro 38066 Operator's Manual

DESCRIPTION
Worm gear
Bracket
Carriage bolt
Flat washer
Locknut
Skids
Flange-head bolts—3/4 in. (1.9 cm)
Flat washers and locknuts
Ignition key

Installing the Handle Assembly

1. Remove the tie straps that secure the control rods to the

handle assembly.

2. Remove the axle pins from both wheels (Fig. 3) and
slide the wheels outward on the axle approximately one
inch (2.5 centimeters).
Figure 3
1. Axle pin (2)
2. Bolts and curved
washers (4)
3. Hold the left side of the handle assembly in the
installation position and insert the upper traction rod
through the loop in the lower traction rod (Fig. 4).
QTY.
653
3. Handle assembly
1
1
1 Installing the chute control gear
1
1
2
2 Installing the skids
2
1 Starting and stopping the engine
Figure 4
1. Lower traction rod
Important
Ensure that the chute control rod
assembly is between the engine and the traction rod
(Fig. 5).
9
USE
m-2669
2. Upper traction rod