Table of Contents
Advertisement
Driving Tips
• To go straight, apply equal pressure to both motion
control levers (Fig. 16).
• To turn, release the pressure on the motion control lever
toward the direction you want to turn (Fig. 16).
Note: The farther you move the traction control levers
in either direction, the faster the machine will move in
that direction.
• To stop, push the motion control levers to neutral.
Stopping the Machine
1. Move the traction control levers to neutral and separate
them to lock them.
2. Disengage the power takeoff (PTO).
3. Turn the ignition key to Off to stop the engine.
4. Set the parking brake when you leave the machine;
refer to Setting the Parking Brake on page 17.
5. Remove the key from the ignition switch.
Caution
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even for a few minutes.
Adjusting the Height-of-Cut
The height-of-cut adjusts from 1-1/2 to 4-1/2 inches (38 to
114 mm) in 1/4 inch (6 mm) increments by relocating the
clevis pin in different hole locations.
1. Raise the height-of-cut lever to the transport position
(also the 4-1/2 inch [114 mm] cutting height position)
(Fig. 17).
Figure 17
1. Height-of-cut lever
2. Remove the clevis pin from the height-of-cut bracket
(Fig. 17).
3. Select the hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and insert
the clevis pin (Fig. 17).
4. Lower the height-of-cut lever onto the clevis pin
(Fig. 17).
Adjusting the Anti-scalp
Rollers
Whenever you change the height-of-cut, adjust the height
of the anti-scalp rollers.
Adjusting the Outer Roller
1. Disengage the PTO, move the motion control levers to
the neutral locked position, and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
20
1
2
m–4122
2. Clevis pin
Advertisement
Table of Contents
