Adjustments; Castor Wheel Tire Pressure; Blade Stopping Time - Toro Groundsmaster 4100-D Service Manual

Adjustments

CAUTION
Never install or work on the cutting deck or lift
arms with the engine running. Always stop en-
gine and remove ignition key first.
See Operator's Manual for adjustment procedures for
the cutting deck on the Groundsmaster 4100−D.

Castor Wheel Tire Pressure

Castor tires on the cutting deck should be inflated to 50
psi (3.5 bar).

Blade Stopping Time

The blades of the cutting deck should come to a com-
plete stop in approximately 5 seconds after the cutting
deck engagement switch is shut down.
NOTE: Make sure the decks are lowered onto a clean
section of turf or hard surface to avoid dust and debris.
To verify blade stopping stopping time, have a second
person stand back from the deck at least 20 feet and
watch one of the cutting deck blades. Have the operator
shut the cutting deck down and record the time it takes
for the blades to come to a complete stop. If this stopping
time is greater than 7 seconds, the braking valve(s)
(R1BR) on the deck drive hydraulic control manifold(s)
need adjustment.
Cutting Deck
Page 8 − 4
Groundsmaster 4100−D