Hydraulic Control Manifold Service: Deck Drive - Toro Groundsmaster 4100-D Service Manual

Hydraulic Control Manifold Service: Deck Drive

15
14
1
15
14
PLUG TORQUE
SAE #2: 60 to 65 in- -lb (6.8 to 9.5 N- -m)
SAE #4: 9 to 11 ft- -lb (12 to 15 N- -m)
SAE #8: 43 to 46 ft- -lb (58 to 62 N- -m)
1. Manifold body
2. Spool logic cartridge (port BY1)
3. Seal kit
4. Spool logic cartridge (port BR1)
5. Seal kit
6. Relief valve (port R1BY)
7. Seal kit
NOTE: The ports on the manifold are marked for easy
identification of components. Example: SV1 is the deck
solenoid valve and P1 is the gear pump connection port.
(See Hydraulic Schematic to identify the function of the
hydraulic lines and cartridge valves at each port loca-
tion).
The control manifolds for the three cutting deck sections
are very similar. Note: When servicing the deck control
manifolds, DO NOT interchange parts from one control
manifold to another.
Hydraulic System
12
30 to 35 ft- -lb
(41 to 47 N- -m)
13
20
15
9
5
4
8. Solenoid valve (port SV1)
9. Seal kit
10. Solenoid coil
11. Nut
12. Relief pilot cartridge (port R1BR)
13. Seal kit
14. Plug (SAE #2)
Page 4 - - 72
7
19
14
9
12 to 15 ft- -lb
17
16
(16 to 20 N- -m)
9
3
2
80 ft- -lb
(108 N- -m)
Figure 57
For solenoid and control valve service procedures, see
Hydraulic Control Manifold Service: 4 Wheel Drive in
this section. Refer to Figure 57 for cartridge valve and
plug installation torque.
Rev. F
6
30 to 35 ft- -lb
(41 to 47 N- -m)
18
Loctite #242
8
50 to 55 in- -lb
(5.6 to 6.2 N- -m)
10
11
15. O- -ring
16. Plug (SAE #4)
17. O- -ring
18. Plug (SAE #8)
19. O- -ring
20. Orifice plug (port MR)
Groundsmaster 4100--D