Adjustments; Wing Deck Position Switches - Toro Groundsmaster 4100-D Service Manual

Adjustments

Wing Deck Position Switches

Adjustment
1. Park machine on a level surface, lower cutting deck,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Remove switch cover from deck to allow access to
position switch that requires adjustment.
NOTE: Use Deck Proximity Switch Adjustment Tool
(TOR4095) to assist with switch adjustment (see Spe-
cial Tools).
3. Loosen two (2) lock nuts that secure switch bracket
to center cutting deck (Fig. 4).
4. When adjusting switch location, the target surface of
position switch should be approximately 0.188" (4.8
mm) from actuator tab on wing deck link (Fig. 5).
5. When wing deck position switch is properly adjusted,
hydraulic motor on wing deck should turn off when wing
deck is raised and wing deck latch opens.
6. For switch testing information, see Wing Deck Posi-
tion Switches in the Component Testing section of this
chapter.
Electrical System
6
1. Position switch
2. Lock nut (2 used)
3. Flat washer (2 used)
4. Switch bracket
3
1. Position switch
2. Actuator tab
Rev. E
Page 5 − 8
5
7
1
Figure 4
5. Carriage screw (2 used)
6. Center cutting deck
7. Screw (2 used)
1
.188"
(4.8 mm)
2
Figure 5
3. Wing deck link
Groundsmaster 4100−D
4
3
2