Epson Stylus Color 1520 User Manual page 134

Troubleshooting
All the lights are flashing.
Possible cause
An internal error may have
occurred.
The printer has finished charging an ink cartridge, but the Pause light is still
flashing.
Possible cause
The ink cartridge clamp isn't
locked down.
The printer needs to
initialize.
The printer sounds like it's printing but nothing prints.
Possible cause
The print head nozzles are
clogged.
The ink cartridges are too
old.
The printer is charging ink.
The printer software installed with Windows 3.1 does not work correctly after you
upgrade to Windows 95.
Possible cause
Your printer software isn't
set up for Windows 95.
After you install your printing software, you see the Windows 95 New Hardware
Found window.
Possible cause
An operating system error
has occurred.
Solution
Turn off your printer, wait five seconds, and turn it on again. If the
lights still flash or stay on, contact EPSON as described in the
Introduction.
Solution
Press down on the clamp to lock it into place.
If the printer is not moving or making noise, but the light is still
flashing after 10 minutes, turn the printer off. If the light is still
flashing when you turn it back on, contact EPSON as described in
the Introduction.
Solution
Clean the print heads. See Chapter 6 for instructions.
For information on cartridge life and replacement instructions, see
Chapter 6.
If you just turned on the printer, it may be charging the ink delivery
system, especially if it has been turned off for a while. This can
take up to 7 minutes; wait until it finishes before printing.
Solution
Reinstall the printer software after installing Windows 95, as
described in the Quick Setup booklet.
Solution
Click Do not install a driver, and then click OK.
7-10