Sharp SW-120NC Instruction Manual page 48

Cutting program setup
When cutting is in operation, press
as page 3 of the cutting status display and setup page)
Material cutting reference
4‐14

Press Home to return to the main control menu.

Press PGUP to go back to the previous setup page.

Press Next to go to the next cutting program setup
page.

Press P01, P05, P10, P15 to quickly jump between
cutting programs (Step 00 ~ 99)
to quickly access the cutting program setup page (the same
This setup page is the same as page 3 of the cutting
status display and setup page.

This reference chart lists out the required blade
speed and cutting rate for each different
material.