Sharp SW-120NC Instruction Manual page 28

2. Use a forklift
Most users choose this method to move their machine because it is easy to set up. Make sure that
the lifting rod can fully withstand the weight of the machine. (Refer to Section 2 – General
Information for Specifications.)

Machine lifting is likely to damage the machine
if not performed properly.
You must have a qualified forklift
operator to perform the job.

You must apply proper forklift technique to
avoid damage to the machine.
Make sure the forks are able to
reach in at least 2/3 of the machine
depth.

You must keep the machine balanced at all
times.
Make sure the forks are centered
before use.
3. Use rolling cylinders
You can use rolling cylinders to move your machine in a small machine shop environment.

You must use rolling cylinders made in material
of proper compressive strength.
3-4
(Illustration only. Refer to Illustration: Lifting
Points for exact locations.)