GE MobileLink CB-1000 Installation And Troubleshooting Manual page 22

Installing Client Bridge on a New Style Trolley
18
Installation Procedures
If you have a new style trolley, use the bracket which already has the
client bridge attached. Follow the steps below to install the client bridge
bracket assembly onto a new MAC 5000 trolley.
1. Be sure that all the information which was entered during client
bridge configuration has been accurately recorded on the Service
Label shown below.
2. Apply the Service Label to the new style client bridge bracket.
127(
The MobileLink kit includes two brackets. For the new style
trolley use the bracket which already has the client bridge and
the power supply attached. The other "empty" bracket has been
included in the kit to add the wireless option to MAC 5000s with
an original style trolley.
3. Position the client bridge assembly under the trolley as shown below.
Slide the cut-out slot on the client bridge bracket onto the bracket
located under the acquisition module tray on the trolley.
MobileLink
2002783-060
MAC5K001
3001
192.168.0.5
255.255.255.0
none
WLAN
Service Label
13A
Revision D