ABB ControlMaster CM15 User Manual page 25

ControlMaster CM15
Universal process indicator
...Device Setup / ...Initial Setup
Config Action
Continue
Hold
Inactive
Level 1 (2) Indicator*
Specific Gravity
Volume Constant
Volume Units
Volume DPs
Custom Template
8.2.4 67
*See Section , page
IM/CM/I–EN Rev. D
1
/ DIN
8
The Config Action parameter is used to determine how the indicator and indicator outputs
behave when the Advanced level is entered – see page 22.
The indicator continues to operate as in Operator level. Outputs continue to operate as
normal.
Digital, relay and analog outputs are held at their value / state when Configuration mode is
entered. When the Advanced level is exited, the indicator returns to the pre-Configuration
mode of operation.
Analog outputs are set to 0 mA. Relays de-energized, digital outputs inactive.
Note. Applicable to level applications only.
Value of the specific gravity currently applied to the process variable.
The constant used to calculate the volume (maximum value 999.9).
The unit of measure used to calculate the volume.
The number of decimal places required (maximum of 4).
If this parameter is enabled, it enables the internal function blocks to be re-linked to create
custom configurations for special application requirements.
These sources are configured in Device Setup / Custom Config – see page 24.
for examples of volume calculations.
7 Advanced Level
23