Sharp FACSIMILE User Manual page 52

Quick Reference Guide
Cut the band which holds the spools
5.
together with scissors, and remove it.
Insert the remaining gear into the right
end of the empty spool and the flange
into the left end of the empty spool.
Make sure the tabs on the gear and the
flange fit into the slots in the ends of
the spool (the gear has two tabs and
the flange has one tab).
1 tab
Flange
Pull the empty spool toward the back of
6.
the compartment, unwinding the film as
you pull.
Insert the empty spool into the back of
7.
the compartment so that the gear and
the flange fit into the slots on the sides
of the compartment.
•
Make sure that the gear engages with the
gear below it.
50
8.
2 tabs
9. Close the print compartment cover,
Gear
10. Load paper in the paper tray and then
Wind the film slightly (rotate the gear
on the right side of the empty spool) so
that there is no slack in the film. Make
sure that both edges of the film wind
onto the spool evenly.
making sure it clicks into place.
•
Caution!
Close the cover slowly to make sure it
doesn't pinch your fingers.
press the following keys to initialize the
film.
•
Note: Paper must be loaded before the
film can be initialized. To load paper, see
Loading the Printing Paper.
FUNCTION
6
INITIALIZE FILM
START