Messages And Signals - Sharp FACSIMILE User Manual

Messages and Signals

Messages and Signals
Display messages
Note: If you have turned on the Caller ID function, see Caller ID in Chapter 7 for
display messages related to Caller ID.
A.M. OFF HOOK
CHECK PAPER SIZE
COVER OPEN
DOCUMENT JAMMED
FAX RX IN MEMORY
FILM END
FUNCTION MODE
LINE ERROR
MEMORY IS FULL
148
When the fax is in A.M. reception mode, this message
appears when the handset of an answering machine (or
extension phone) connected to the fax has been lifted.
An incorrect size of paper has been loaded in the paper
tray. Remove the paper and load A4-size paper.
The print compartment cover. Close it.
The original document is jammed. See the following
section, Clearing Paper Jams.
A fax has been received in memory because the
imaging film needs replacement, you have run out of
printing paper, or the paper is jammed. After you fix the
problem, press the START key to print out the fax.
The imaging film may need replacement. Check the film
and replace if necessary.
The FUNCTION key has been pressed.
Transmission or reception was not successful. Press the
STOP key to clear the message and then try again. If
the error persists, see Line Error on page 143.
The memory is full. This may occur during fax reception
if too much data is received before the pages can be
printed out. If faxes have been received to memory
because printing is not possible (an additional message
will indicate the problem), resolve the problem so that
printing can continue (see Substitute Reception to
Memory on page 104). If you are attempting to transmit
from memory, see If the memory becomes full on page
128.