Table of Contents
Advertisement
Blade descend pressure and speed control panel
The part of control panel is where cutting pressure and saw bow descend speed can be adjusted.
1
2
3
Cutting pressure and speed control panel
Human-Machine-Interface (HMI) Touch Screen
This HMI touch screen displays operation messages so that the operator is able to understand the
system condition. It also provides different operating modes and selections for the operator to work
with. During a cutting job, the operator can still enter the system and make changes to the cutting
operation as needed.
Do not wipe or clean the screen with volatile solvents.
Do not overexert pressure on the screen. The touch screen is very sensitive; all buttons on the
screen just need a slight touch to operate.
All range parameters in HMI interface are configured under the "manual" mode.
1. Cutting pressure control knob
This pressure control knob is used to adjust the
cutting pressure of the blade.
Turning the knob clockwise increases the cutting
pressure.
To obtain a good cutting result, choose the right
cutting pressure by turning the knob until it points
to your material on the color chart.
2. Cutting pressure gauge
The gauge shows the current cutting pressure
value, which appears upon a started blade.
3. Blade descend speed control knob
This knob is used to adjust the descend speed of the
saw blade.
Turning the knob clockwise increases the blade
descend speed.
Blade descend speed is a determining factor to a
good cutting time and quality cutoff surface.
Set the blade descend speed in accordance with the
cutting pressure control knob.
Also commonly known as the flow control valve.
4-7
Advertisement
Table of Contents
