Linking The Incomplete Clips; Playing Back Clips - Panasonic AJ-UPX360ED Operating Instructions Manual

t Use a sufficiently charged battery or AC adaptor.
t It may not be possible to completely repair depending on the condition of the data.
t To restore the clips, it is necessary that the clips are recorded for more than a certain amount of time. Especially in the following cases, the clips may
not be restored, because the number of frames to be recorded is small.
‑ When the variable frame rate recording function is enabled, and the frame rate lower than the system frequency is set.
‑ When the interval recording function is enabled.
t The clips shot before the power was turned off will not be able playback if the repair fails.
Also, it may not be possible to record any more.
t If data recorded with other device is repaired, it may not be able to play back on the camera or other device.
t If the repair failed, turn off the camera, and turn it back on after waiting for a while. If the repair fails repeatedly, format with the camera. All data will be
erased when it is formatted, and it cannot be restored.
t Display of the thumbnail become slower when the thumbnail information is repaired.

Linking the incomplete clips

The linked P2 clips recorded over multiple memory cards may become incomplete clips due to being copied separately from each memory card.
These can be restored to original linked clips by using the link function.
Only the P2 clips can be linked.
1
Press the <THUMBNAIL> button.
The thumbnail screen is displayed.
2
Press the <MENU> button while the thumbnail screen is displayed.
The menu is displayed.
3
Select the [THUMBNAIL] menu → [CLIP] → [RE-CONNECT].
4
Select [SELECT].
The thumbnail screen is displayed.
5
Select the clip to link in the thumbnail screen.
is displayed next to the thumbnail number on the selected clip.
6
Select [SET].
f This can also be selected by pressing and holding the multidial.
7
Select [SET] when the confirmation message is displayed.
This starts linking of the clip.
8
When the completion message is displayed, select
@
NOTE
t Even though some clips are reconnected,
t Linking is not possible when the card with the clips to link is write-protected.

Playing back clips

1
In the [SYSTEM] menu → [FREQUENCY], select the system frequency to play back.
2
In the [SYSTEM] menu → [FILE FORMAT], select the file format to play back.
3
In the [SYSTEM] menu → [REC FORMAT], select the signal format and codec mode to play back.
4
Press the <THUMBNAIL> button.
The thumbnail screen is displayed.
5
Press the <MENU> button while the thumbnail screen is displayed.
The menu is displayed.
Chapter 6 Playback — Thumbnail operation
.
will remain displayed when all the clips constituting the original linked clip are not present.
– 159 –