Table of Contents
Advertisement
r When the recording mode is AVCHD
SDHC memory cards, SDXC memory cards and microP2 cards can be used.
Recording bit rate or recording function
All
Preventing unintentional erasing
Writing, erasing and formatting data is prohibited by setting the write-protection switch of the memory card to the LOCK side.
Status of the card access lamp and memory card
Card access lamp
Orange (illuminated)
Green (illuminated)
Orange (flashing)
Orange (rapidly flashing)
Green (slowly flashing)
Off
@
NOTE
t The card access lamp will not illuminate or flash when the [OTHERS] menu → [LED] → [ACCESS LED] → [OFF] is set.
Chapter 3 Preparation — Preparing the memory card
Speed Class
Speed Class 4 or higher
Or the microP2 card A series, microP2 card B series
Write-protection switch
Recording target
Recording possible
Accessing card
Recognizing memory card
Error
No remaining recording capacity
Write-protected
Recording not possible
No memory card inserted
Illegal format
Card not supported
Setting to [NETWORK] menu →
[NETWORK FUNC] → [NDI|HX]
microP2 card formatted with
encryption with CPS password
During card reader mode
– 42 –
Memory card status
Both loading/writing are permitted. Current recording target.
Both loading/writing are permitted.
Loading/writing are currently being performed.
The memory card is being recognized.
An error has occurred. This will flash even if the memory card is not
inserted when an error has occurred.
No recording capacity left on the memory card. Only loading is possible.
The write-protection switch of the memory card is set to the LOCK side.
It cannot record with the recording format that is currently set. Change
the recording format or use a memory card compatible with the recording
format to record.
A memory card has not been inserted.
It is not the correct format. Reformat the card.
This is a card that cannot be used with the camera, such as MMC (Multi
Media Card).
Cannot record and play back. The functions other than recording and
playback (loading of the scene file, etc.) can be used.
Cannot be used with the camera. When formatted with the camera, it can
be used as a microP2 card that is not encrypted.
The card 1 access lamp/card 2 access lamp turns off when not
accessing.
Example of card display
Advertisement
Table of Contents
