Table of Contents
Advertisement
<Diagnosis>
When the raidcheck command finishes normally, it returns exit code 0.
If the command returns abnormally, one of the error messages listed in Table 5-4 is
displayed, and the command returns an exit code other than 0. As an exception, if message
number 3 or 5 is displayed, the command returns exit code 0.
No.
Error message
1
Usage:raidcheck [/START [/q]]
2
Invalid argument. (%1)
Consistency check is already running.
3
RAID condition is not OPTIMAL.
4
Consistency check is not running.
5
This command cannot execute in simulation
6
mode.
This command is not available
7
simultaneously.
8
The array is not configured correctly.
9
An error occurred in %1. errorcode = %2
10 You do not have the privilege to execute this
command option.
Please execute this command option again on
"Administrator: Command Prompt".
11 Access denied.
Log on console session,
And execute this command option again on
"Administrator: Command Prompt".
12 raidcheck: This function was executed on a
non-RAID model.
Table 5-4 Error Messages of the raidcheck Command
5. CONTROLLING THE HARDWARE
There is an error in the specified options.
Specify correct options.
Specified option %1 is not correct.
Consistency check has already started and is running.
The RAID state is not normal.
Consistency check has not started.
This command cannot be executed in the simulation mode.
Multiple instances of this command cannot run at the same time.
The array has not been configured properly.
An unexpected error (%2) occurred in the function (%1). Retry
the command. If the same error message persists, restart this
equipment.
You do not have administrator privileges.
Log on to the computer using an administrator account and run
the command again. If User Account Control (UAC) is enabled,
start the command prompt with administrator privileges and run
the command.
You cannot use this command with this option from a remote
session.
Log on to a console session and run the command again. If User
Account Control (UAC) is enabled, start the command prompt
with administrator privileges and run the command.
The command was executed on a model other than D Model.
This command can be executed on D Model only.
5-13
Description
Advertisement
Table of Contents
