Huawei TE30 Product Overview page 12

Videoconferencing endpoint

Hide thumbs Also See for TE30:

Table of Contents

TE30 Videoconferencing Endpoint

Product Overview

In the CloudVC on-premises networking scheme, the endpoint TE30 can hold multipoint

conferences using its built-in MCU, without any intervention of the SMC2.0 or MCU. The

built-in MCU makes conference rooms of small- and medium-sized enterprises video-

enabled.

Figure 3-2 Built-in MCU-based network

The network is described as follows:

Issue 03 (2018-06-30)

Figure 3-2

shows the built-in MCU-based network of the endpoint.

After having the built-in MCU enabled, the endpoint TE30 can hold both encrypted and

unencrypted conferences.

– An unencrypted conference can hold a maximum of three 576p 30 fps HD video

sites and three audio sites, besides the site that initiates the conference. Each video

site occupies 1.5 Mbit/s bandwidth. The total bandwidth occupied by the conference

cannot exceed 4.5 Mbit/s.

– An encrypted conference can hold a maximum of three 576p 30 fps HD video sites,

besides the site that initiates the conference. Each video site occupies 1 Mbit/s

bandwidth. The total bandwidth occupied by the conference cannot exceed 3

Mbit/s.

SD and HD video sites and audio-only sites of the H.323 or SIP type can join

conferences on this network.

NOTE

Audio-only sites can join conferences using IP phones only when the SC is deployed on the

network.

This network supports presentation sharing through the H.239 protocol, as well as

simultaneous video and presentation sharing through the Binary Floor Control Protocol

(BFCP).

3 Application Scenarios

Table of Contents