Table of Contents
Advertisement
Operating modes
en
ÇOperating modes
T his appliance can be used in air extraction mode or
O p e r a t i n g m o d e s
circulating-air mode.
Exhaust air mode
The air which is drawn in is cleaned
by the grease filters and conveyed to
the exterior by a pipe system.
The exhaust air must not be conveyed into a
Note:
functioning smoke or exhaust gas flue or into a shaft
which is used to ventilate installation rooms which
contain heat-producing appliances.
Before conveying the exhaust air into a non-
■
functioning smoke or exhaust gas flue, obtain the
consent of the heating engineer responsible.
If the exhaust air is conveyed through the outer wall,
■
a telescopic wall box should be used.
Circulating-air mode
The air which is drawn in is cleaned by the
grease filters and an activated carbon filter
and conveyed back into the kitchen.
To bind odours in circulating-air mode, you must
Note:
install an activated carbon filter. The different options for
operating the appliance in circulating-air mode can be
found in the brochure. Alternatively, ask your dealer.
The required accessories are available from specialist
outlets, from customer service or from the Online Shop.
14
KBefore using for the first
time
P lease read the following information before using the
B e f o r e u s i n g f o r t h e f i r s t t i m e
appliance for the first time:
Clean the appliance and all accessory parts thoroughly.
Before you can use your new appliance, you must apply
certain settings.
Switch the hob on and off using the main switch
Setting Home Connect
When you first switch on the appliance, you will be
prompted to set up your home network. The
will be lit dimly for a few seconds on the display panel.
To begin setting up the connection, touch the
sensor and proceed in accordance with the
D
information given in the section entitled ~ "Home
Connect".To exit initial set-up, touch any sensor.
Setting the operating mode
The appliance is supplied with a preset air recirculation
mode.
When the hob is installed with an air outlet to the
outside, you must configure the setting
mode. See section ~ "Basic settings".
#
.
symbol
D
in this
™‚ˆ
Advertisement
Table of Contents
