Operating Modes - Siemens EH8 BE15 Series Information For Use

Induction hob with integrated ventilation system
Table of Contents

Advertisement

en Operating modes
5.5 Distribution of the cooking zones
The specified power has been measured with the
standard pots, which are described in IEC/EN
60335-2-6. The power may vary depending on the size
of the cookware or cookware material.
B
A
Area
Highest power level
​ ⁠ 21 cm dia-
Power level 9
meter
powerBoost
6  Operating modes
You can use your appliance in air extraction mode or
circulating-air mode.
6.1 Air extraction mode
The air which is drawn in is cleaned by the grease fil-
ters and conveyed to the exterior by a pipe system.
The air must not be discharged into a
flue that is used for exhausting fumes
from appliances burning gas or other
fuels (not applicable to appliances that
only discharge the air back into the
room).
¡ If the exhaust air is to be conveyed
into a non-functioning smoke or ex-
haust gas flue, you must obtain the
consent of the heating engineer re-
sponsible.
¡ If the exhaust air is conveyed
through the external wall, a tele-
scopic duct should be used.
7  Before using for the first time
Observe the following recommendations.
7.1 Preparing the appliance
To ensure correct operation, you must arrange the
components in this order:
1.
Insert the filter.
2.
Insert the metal grease filter.
Note: Never operate the appliance without the metal
grease filter and the overflow container.
8
B
A
2200 W
3700 W
Area
Highest power level
​ ⁠ 18 cm dia-
Power level 9
meter
powerBoost
5.6 Cooking zone
Before you start cooking, check whether the size of the
cookware fits the cooking zone that you want to use for
cooking:
Area
Cooking zone type
​ ⁠
Single-circuit cooking zone
5.7 Residual heat indicator
The hob has a residual heat indicator for each cooking
zone. Do not touch the cooking zone if the residual
heat indicator is lit.
Display
Meaning
​ ⁠
The cooking zone is hot.
​ ⁠
The cooking zone is warm.
6.2 Air recirculation mode
The air which is drawn in is cleaned by the grease fil-
ters and an odour filter, and conveyed back into the
room.
To bind odours in circulating-air mode,
you must install an odour filter. The dif-
ferent options for operating the appli-
ance in circulating-air mode can be
found in our catalogue. Alternatively,
ask your dealer. The required accessor-
ies are available from specialist retail-
ers, from customer service or from the
Online Shop.
7.2 Setting the operating mode
The appliance is supplied with a preset circulating-air
mode.
When your hob is installed with an air outlet to the out-
side, you must configure the setting  ​ ⁠ ​ ⁠ ​ ⁠ to this mode.
You can find additional information about this in the
section entitled
→ "Basic settings", Page 12
1800 W
3100 W

Advertisement

Table of Contents
loading

Table of Contents