Advertisement
DANGER
In certain conditions, fuel is extremely flammable
and highly explosive. A fire or explosion from fuel
can burn you and others and can damage property.
• Fill the fuel tank outdoors, in an open area, when
the engine is cold. Wipe up any fuel that spills.
• Do not fill the fuel tank inside an enclosed trailer.
• Do not smoke when handling fuel, and stay
away from an open flame or where fuel fumes
may be ignited by a spark.
• Store fuel in an approved container and keep it
out of the reach of children. Do not buy more
than a 30-day supply of fuel.
• Do not operate without entire exhaust system in
place and in proper working condition.
1. Park the machine on a level surface.
2. Using a clean rag, clean the area around fuel tank cap.
3. Remove the cap from the fuel tank.
4. Fill the tank until the level is to the bottom of the filler
neck with diesel fuel.
5. Install fuel tank cap tightly.
Note: If possible, fill the fuel tank after each use. This
will minimize possible buildup of condensation inside
the fuel tank.
Checking the Engine-Oil Level
Before you start the engine and use the machine, check the oil
level in the engine crankcase. The oil should just touch the
end of the dipstick. See your Authorized Toro Dealer.
Checking the Cooling System
Before you start the engine and use the machine, check the
cooling system.
Checking the Hydraulic-fluid Level
Before you start the engine and use the machine, check the
hydraulic fluid level; refer to
Level (page
21).
Checking the Hydraulic-fluid
Starting/Stopping the Engine
To start the engine, complete the following:
1. Open the front hood.
2. Turn the battery disconnect switch to the On position.
3. Close and latch the hood.
4. Turn the ignition key, on the rear control panel, to the
Run position.
If the Wait-to-Start light illuminates, wait until it turns
off before proceeding.
5. Turn the ignition key to the Start position until the
engine starts, then release it.
To stop the engine, turn the ignition key to the Off position.
In an emergency, you can also stop the engine and all
processes by pressing the Engine-stop button on either the
drive pendant or the control panel.
Driving the Machine
1. Walk around the machine to ensure that no one is near
it. Ensure that all bystanders are clear of the area where
you will be moving the machine.
2. Connect the drive pendant to the right receptacle on
the bottom of the rear control panel.
3. With the pendant in hand, walk at least 6 feet to the
side of the machine. Be sure to keep this safe distance
whenever moving the machine.
4. Press and hold the operator presence button on the
drive pendant.
5. Use the speed switch on the pendant to increase or
decrease the engine speed as desired.
6. Set the desired travel speed, using the speed switch.
7. Use the joy stick to move the machine as desired.
21
Figure 19
g194881
Advertisement
