Advertisement
Indicator Light State
Green light is blinking rapidly
Green light is illuminated
without blinking
Yellow light is blinking slowly
Red light is blinking
Replacing the Handheld Transmitter
Batteries (Standard Range)
1. Loosen the 4 screws securing the battery cover
14).
Figure 14
1. Handheld transmitter
2. Battery cover
2. Remove the cover
(Figure
Figure 15
1. Handheld transmitter
3. Remove the existing batteries.
4. Install 3 new, AAA batteries in the orientation shown
in
Figure
16.
Meaning
The transmitter is transmitting
to the base unit
A button on the transmitter is
currently pressed
The batteries are low; change
the batteries. If you do not
change the batteries soon, the
handheld will power down.
The transmitter is actively
receiving messages from the
base unit.
(Figure
3. Screws
15).
2. Battery cover
Important: Ensure that you install the batteries
in the correct polarity orientation or you could
damage the transmitter.
1. Handheld transmitter
5. Replace the cover and secure it with the screw removed
previously.
Tighten the screws enough to ensure that the sealing
gasket is compressed, but do not over tighten them.
Associating the Handheld Transmitter
with the Base Unit (Standard Range)
If the handheld transmitter ever stops communicating with
g023887
the base unit, or if you replace it with a new transmitter, you
need to associate the transmitter to the base unit as follows:
1. Ensure that the machine is turned off.
2. Ensure that the handheld transmitter is not active (i.e.,
no lights are on).
3. Stand near the rear control panel of the machine.
4. Simultaneously press and hold the On and Off buttons.
The Green light illuminates.
5. Continue holding the buttons until the Yellow light
begins flashing, then release the buttons.
The Red light begins flashing allowing you 2 seconds
to press the next button.
6. Press and hold the On button
The Red light turns off and the Green and Yellow
g023888
lights illuminate.
Important: If you do not press this button within
2 seconds, you will have to start this procedure
over again.
7. Continue holding the On button and turn on the
machine to power the base unit.
The base unit and handheld establish a communication
link while you hold the button. Once the process is
17
Figure 16
2. AAA batteries
g023889
Advertisement
