Unfolding The Handle - Toro Flex-Force Power System 51833 Operator's Manual

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
Note:
The battery pack is not fully charged when you
purchase it. Before using the tool for the first time,
refer to Charging the Battery Pack (page
1

Unfolding the Handle

Parts needed for this procedure:
1 Allen wrench
Procedure
1. Unfold the handle (A of
2. Align the locking button on the lower shaft with the slotted hole on the upper shaft and slide the 2 shafts
together (B and C of
Note:
The locking button clicks into the slotted hole when the shafts are secured (D of
3. Using the provided Allen wrench, tighten the screw on the shaft connector until it is secure (E of
Description
Allen wrench
Auxiliary handle assembly
12).
Figure 1).
Figure 1).
Qty.
1 Unfold the handle.
1 Install the auxiliary handle.
7
Use
Figure 1).
Figure 1).