Toro Flex-Force 51831T Operator's Manual

Toro Flex-Force 51831T Operator's Manual

13in or 15in 60v max string trimmer
Hide thumbs Also See for Flex-Force 51831T:

Advertisement

Quick Links

Register at www.Toro.com.
Original Instructions (EN)
Flex-Force Power System
or 15in 60V MAX String Trimmer
Model No. 51831—Serial No. 320000001 and Up
Model No. 51831T—Serial No. 320000001 and Up
Form No. 3440-153 Rev A
13in
*3440-153*

Advertisement

Table of Contents
loading

Summary of Contents for Toro Flex-Force 51831T

  • Page 1 Form No. 3440-153 Rev A Flex-Force Power System ™ 13in or 15in 60V MAX String Trimmer Model No. 51831—Serial No. 320000001 and Up Model No. 51831T—Serial No. 320000001 and Up *3440-153* Register at www.Toro.com. Original Instructions (EN)
  • Page 2: Important Safety Instructions

    Model 51841). Using this product for purposes other than its intended use could prove dangerous to you Use only the battery pack specified by Toro. and bystanders. Using other accessories and attachments may increase the risk of injury and fire.
  • Page 3 Dress properly—Wear appropriate clothing, battery pack above 68°C (154°F) or incinerate including eye protection; long pants; substantial, it. Replace the battery pack with a genuine Toro slip-resistant footwear; rubber gloves; and battery pack only; using another type of battery hearing protection. Tie back long hair and do not pack may cause a fire or explosion.
  • Page 4 Do not attempt to service or repair the appliance, battery pack, or battery charger except as indicated in the instructions. Have an Authorized Service Dealer perform service using identical replacement parts to ensure that the product is safely maintained. Store an idle appliance indoors in a place that is dry, secure, and out of the reach of children.
  • Page 5: Safety And Instructional Decals

    Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal144-3098 144-3098 decal144-3094 144-3094 1. The battery pack is 3.
  • Page 6 decal144-3085 144-3085 decal139-5210 139-5210 1. Warning—read the Operator’s Manual; stay away from moving parts; keep all guards in place; wear eye protection; do not operate in wet conditions. decal140-8475 140-8475 1. Read the Operator’s 3. Keep away from open fire Manual.
  • Page 7 Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. Allen wrench Unfold the handle. Auxiliary handle assembly Install the auxiliary handle. Guard Install the guard. Note: The battery pack is not fully charged when you purchase it.
  • Page 8: Unfolding The Handle

    Unfolding the Handle Parts needed for this procedure: Allen wrench Procedure Unfold the handle (A of Figure Align the locking button on the lower shaft with the slotted hole on the upper shaft and slide the 2 shafts together (B and C of Figure Note: The locking button clicks into the slotted hole when the shafts are secured (D of...
  • Page 9: Installing The Auxiliary Handle

    Installing the Auxiliary Handle Parts needed for this procedure: Auxiliary handle assembly Procedure Separate the auxiliary handle from the handle plate by removing the 2 screws (A of Figure Line up the auxiliary handle with auxiliary handle plate on the trimmer handle (B of Figure Secure the auxiliary handle to the handle plate with the 2 previously removed screws (C of Figure...
  • Page 10: Installing The Guard

    Installing the Guard Parts needed for this procedure: Guard Procedure Using the provided Allen wrench, remove the 2 socket head screws, 2 washers, and 2 spacers from the trimmer base (A of Figure Align the guard onto the trimmer base (B of Figure Secure the guard onto the base of the trimmer with the 2 socket head screws, 2 washers, and 2 spacers previously removed (C of...
  • Page 11: Product Overview

    Specifications Product Overview Model 51831/T Rated 60V DC maximum, 54 VDC nominal usage Voltage Charger 88602 or 88610 (included with 51831) Type Battery Type 88620 (included with 51831), 88625, 88640, 88660, or 88675 Appropriate Temperature Ranges Charge/store the battery pack 5°C (41°F) to 40°C (104°F)* Use the battery pack at -30°C (-22°F) to 49°C (120°F)
  • Page 12: Operation

    Operation Starting the Trimmer Make sure that the vents on the trimmer are clear of any dust and debris. g330416 Figure 8 1. Lockout trigger 2. Run trigger Shutting Off the Trimmer To shut off the trimmer, release both triggers. Whenever you are not using the trimmer or are transporting the trimmer to or from the work area, remove the battery pack.
  • Page 13: Charging The Battery Pack

    Charging the Battery Pack Battery pack and/or battery charger is over or under the appropriate temperature range Important: The battery pack is not fully charged Battery pack charging fault* when you purchase it. Before using the tool for blinking the first time, place the battery pack in the charger and charge it until the LED display indicates the *Refer to Troubleshooting (page 18)
  • Page 14: Advancing The Line Manually

    Advancing the Line Using the Bump Feed Run the tool at full throttle. Tap the bump button on the ground to advance the line. The line advances each time the bump button is tapped. Do not hold the bump button on the ground.
  • Page 15: Operating Tips

    Adjusting the Cutting Swath The trimmer comes from the factory with a cutting swath of 33.0 cm (13 inches) as shown in A of Figure Refer to the following instructions to adjust the swath to 38.1 cm (15 inches) as shown in D of Figure Remove the swath blade from the bottom of the guard by removing the 2 screws holding it in place using the provided Allen wrench (B of...
  • Page 16: Maintenance

    Maintenance Replacing the String Important: Use only 2 mm (0.080 inch) After each use of the trimmer, complete the following: monofilament string (the manufacturer Part No. 88201). Remove the battery from the trimmer. Remove the battery pack and clean any debris Wipe the trimmer clean with a damp cloth.
  • Page 17: Preparing The Battery Pack For Recycling

    Call2Recycle seal, please contact your local municipality for more information on how to responsibly recycle the battery. If you are located outside of the US and Canada, please contact your authorized Toro distributor.
  • Page 18: Troubleshooting

    Troubleshooting Perform only the steps described in these instructions. All further inspection, maintenance, and repair work must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the problem yourself. Problem Possible Cause Corrective Action The tool does not start.
  • Page 19 California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in California, or manufacturing products that may be sold in or brought into California.

This manual is also suitable for:

Flex-force 51831Flex-force power system 51831Flex-force power system 51831t320000001

Table of Contents