Junction Panels; Cavity Combining Rfds Intercabinet Cabling; Figure 4-2 Site Controller Junction Panel (Rear View); Table 4-11-5 Channel Omni Site Intercabling - Motorola iDEN Site Controller System Manual

Chapter 4 Installation
Intercabling Connections

Junction Panels

OUT 3 OUT 2
5MHz/1PPS
SITE GROUND
NOTE: Three additional groud studs are used for SRRC, SRSC, and 23" Racks.
Figure 4-2 Site Controller junction panel (rear view)

Cavity Combining RFDS Intercabinet Cabling

4-8
Most of the intercabling is accomplished on the junction panel located at the
top-rear of the equipment cabinet. Figure 4-2 shows the junction panel.
The junction panel is accessed from the rear of the cabinet. All intercabinet
cabling runs up and out the top of each cabinet into the cable tray assembly.
The OUT connection for each cable has been connected by the factory.
Installation of intercabinet cabling is completed by connecting the free end
of each cable into the appropriate IN connector of adjacent cabinets.
OUT 1 10B2-3 10B2-2 10B2-1
ETHERNET
Intercabling between the Control Cabinet and the RF Cabinets for systems
equipped with Cavity Combining RF Distribution Systems is listed below.
Choose the appropriate table below, then refer to the appropriate instructions
for connecting the required intercabling.
1-5 Channel Omni Site Cables
Table 4-1 lists the required cables for an omni site (single sector).

Table 4-11-5 Channel Omni Site Intercabling

Cable PN
0112004Z29 Ethernet
0112004Z29 5 MHz/1 PPS
3084225N42 Alarms
3082070X01 PCCH
Redundancy
TX OUT GPS A GPS B
Description Qty.
1
1
1
1
Gen 3 Site Controller System Manual
RX3 RX2 RX1
SITE GROUND
Connection
to RF Cabinet #1
Site controller
to RF Cabinet #1
Site controller
EAS/EAS2 to RF Cabinet #1
to RF Cabinet #1
Site controller
68P80801E30-A 5/1/2002
EBTS315
032801JNM