Motorola iDEN Site Controller System Manual page 135

Gen 3 Site Controller System Manual
Site Controller
Verification
68P80801E30-A 5/1/2002
The cabinet verification consists of:
Section
Site Controller
Verification
Loading the Base
Radios
Standby Site Controller
Status
Base Radio
Registration
T1 Connection Test
EAS/EAS2 Alarm
Checkout
GPS Status
Site Reference
Page This section . . .
6-3 describes the Site Controller start up
sequence and configuration
6-12 describes how to download the application
code to each Base Radio
6-14 describes how to check the status of the
standby site controller system
6-15 describes how to check the registration and
status of each Base Radio within the system
6-17 describes how to locally manufacture a T1
test cable; also how to set-up and perform a
loop-back test on the T1 line
6-25 describes how to verify that EAS/
EAS2-monitored site alarms work properly
6-29 describes how to check the alarm, GPS, and
on-line status of the GPS
6-31 provides a timing reference and a frequency
reference to the base radios.
Chapter 6 System Testing
Site Controller Verification
6-3