Mmi Commands; Access Level; Conventions - Motorola iDEN Site Controller System Manual

Chapter 8 Software Commands

MMI Commands

MMI Commands

Access Level

Conventions

8-2
MMI commands are input from a service computer to the system RS-232
serial port (19200 bps, 8 data bits, 1 stop bit, no parity). The RS-232 port is
accessed from the site controller Service Access connector.
The service technician enters the MMI commands to communicate with the
site controller at the system level. The system response is returned to the
service computer via RS-232.
The appropriate test procedures use these commands to test and configure
the system. The test procedure for the site controller appears in the System
Testing chapter of this manual and the test procedure for the BR appears in
the EBTS System Manual (on CD: 98P80800A17) Base Radio chapter.
Site controller commands are available through the use of the password
factory. This password allows the service technician access to a subset of
the MMI command set. This subset is used for field service and does not
allow permanent configuration of the site controller.
The factory password is a default password that is programmed
Note:
during manufacturing. The password may be changed by the
Operations and Maintenance Center (OMC).
The syntax for each command is presented as follows:
bold text shows the actual text to be typed at the iSC> prompt to invoke a
I
command or action
italic text shows the syntax used for a command
I
text enclosed in brackets [ ] indicates an optional value that may be
I
entered.
Where items are separated by vertical bars | , the items are the applicable
I
choices that may be entered
italic text enclosed in braces < > indicates a corresponding selection or
I
parameter that must be entered for the command to execute
Gen 3 Site Controller System Manual
68P80801E30-A 5/1/2002