Motorola iDEN Site Controller System Manual page 180

Chapter 8 Software Commands
Site Controller Commands
DELOOP
PING BR
8-10
Syntax:
deloop <line #>
The 'deloop' command takes any Tl /E1 line out of a Remote Loopback
mode. The line # argument can be any Tl/El line 1 - 4. To deloop all TI/El
lines, enter 0 for the line # argument.
Example:
iSC>deloop 1
Syntax:
ping br
The purpose of this command is to check ethernet connectivity. This
command sends a ping message to all Base Radios connected to
ethernet and displays the cabinet and position number and the ethernet
address for BRs that respond successfully.
Cab/pos number and ethernet address will be displayed for BRs that respond
successfully:
Quad BR must be switched to test mode, by performing diagnostic
Note:
reset (press reset button located on the BR front panel and follow on
screen instructions), in order to communicate with iSC. Refer to
System Testing section in Volume 1 (System Installation and
Testing) of EBTS manual for more information.
Gen 3 Site Controller System Manual
68P80801E30-A 5/1/2002