Recommended Parts; Table 3-10 Recommended Parts For Installation - Motorola iDEN Site Controller System Manual

Gen 3 Site Controller System Manual

Recommended parts

68P80801E30-A 5/1/2002
Table 3-10 lists the recommended parts for installation. These are not
included as part of the system shipment and must be procured locally. All
model numbers are Motorola part numbers, unless noted otherwise.

Table 3-10 Recommended parts for installation

Part Type/size
anchor kit #02100-13
bolts 3/8x16x3/4"
1/4x20x1/2"
colored red, black, green,
vinyl tape brown, yellow, and
white
grease anti-oxidant
lockwashers split - 3/8"
split - 1/4"
lugs 2 hole 1" center
various sizes
lugs 2 hole 1" center
power #6 AWG stranded Cu
cables (red and black)
4/0 stranded Cu (red
and black)
ground #2 AWG stranded Cu
cables (green)
#6 AWG stranded Cu
(green)
NOTE: Refer to the Parts and Suppliers appendix for other cable sizes needed where
equipment cabinets are not next to each other.
Chapter 3 Pre-Installation
Recommended Tools, Equipment, and Parts
Supplier
Hendry cabinet floor anchors
locally Breaker Panel on
procured Power Supply Rack
locally DC return bus,
procured Power Supply Rack
locally wire identification
procured
locally battery terminal
procured corrosion control
locally Breaker Panel,
procured Power Supply Rack
locally DC return bus,
procured Power Supply Rack
locally battery connection;
procured 3/8" bolt, 4/0 Cu
locally DC return
procured connection; 1/4"
bolt, #6 Cu
locally Power Supply wiring
procured
locally Power Supply wiring
procured
locally cabinet grounding
procured
locally cabinet grounding
procured
Where used
3-35